商品详情
GENERAL DESCRIPTION
The AD7879W is a 12-bit successive approximation analog-to
digital converters (SAR ADCs) with a synchronous serial
interface and low on-resistance switches for driving 4-wire
resistive touch screens. The AD7879W works with a very low
power supply—a single 1.6 V to 3.6 V supply—and feature
throughput rates of 105 kSPS. The devices include a shutdown
mode that reduces current consumption to less than 6 µA.
To reduce the effects of noise from LCDs and other sources, the
AD7879W contains a preprocessing block. The preprocessing
function consists of a median filter and an averaging filter. The
combination of these two filters provides a more robust solution,
discarding the spurious noise in the signal and keeping only the
data of interest. The size of both filters is programmable. Other
user-programmable conversion controls include variable
acquisition time and first conversion delay; up to 16 averages
can be taken per conversion. The AD7879W can run in slave
Rev. 0
Information furnished by Analog Devices is believed to be accurate and reliable. However, no
responsibility is assumed by Analog Devices for its use, nor for any infringements of patents or other
rights of third parties that may result from its use. Specifications subject to change without notice. No
license is granted by implication or otherwise under any patent or patent rights of Analog Devices.
Trademarks and registered trademarks are the property of their respective owners.
FUNCTIONAL BLOCK DIAGRAM
REF+
X–Y–X+Y+
FILTERING
RESULT
REGISTERS
CONTROL
REGISTERS
SEQUENCER
AND TIMER
REF
TEMPERATURE
SENSOR
TO
RESULT
REGISTERS
6-TO-1 MUX
AD7879W/
AD7879-1W
VCC/REF
X+
X
Y+
Y
GND
AUX/VBAT/GPIO
PENIRQ/INT/DAV
SERIAL PORT
DIN/
ADD1
DOUT/
SDA
SCL CS/
ADD0
12-BIT
SARADC
REF
Figure 1.
mode or standalone (master) mode, using an automatic
conversion sequencer and timer.
The AD7879W has a programmable pin that can operate as an
auxiliary input to the ADC, as a battery monitor, or as a GPIO.
In addition, a programmable interrupt output can operate in
three modes: as a general-purpose interrupt to signal when new
data is available (DAV), as an interrupt to indicate when limits
are exceeded (INT), or as a pen-down interrupt when the
screen is touched (PENIRQ). The AD7879W offers temperature
measurement and touch-pressure measurement.
The AD7879W is available in a 16-lead, 4.4 mm × 5.0 mm
TSSOP and 16-lead 4 mm × 4 mm LFCSP. Both packages
support an SPI interface (AD7879W) or an I2C® interface